Attack on Titan The Wall Sleeves: 5-Step Fit Check
By Japanime Games | Your Source for the Best Anime Board | Published: 2026-10-31
Category: Product Reviews
Use this five-step check to confirm Attack on Titan The Wall sleeves fit your cards, then sleeve a deck cleanly without splits or bent corners.
Quick answer
Measure one card against the listed 66 mm width and 92 mm length before you sleeve a whole deck. If your card is a standard Magic-sized card, the Attack on Titan The Wall sleeves are the right starting point, and you can confirm the fit with a single test card.
Why the listed dimensions decide the fit
The Wall sleeves are listed at 66 mm wide and 92 mm long, which is the standard-size range used for Magic-sized cards. That measurement is the only reliable fit check because card thickness, finish, and edge wear vary between games and printings.
Sleeve count matters too: each pack contains 60 sleeves. That is enough for a full constructed deck in many games, but it leaves no spare if a sleeve splits mid-event. If you plan to double-sleeve or keep a sideboard, count your cards before ordering.
Where standard-size sleeves fall short
Standard-size sleeves are not a universal fit. Cards printed at a smaller or larger trim, and cards with heavy foil curling, can sit loosely or bind inside a 66 x 92 mm sleeve. The Wall sleeves are also not advertised as inner sleeves, so do not assume they will layer under a second outer sleeve.
If your game uses a non-standard card size, this sleeve is the wrong product regardless of the artwork. Check the card's measured dimensions first, then choose a sleeve built for that size.
Five steps to check and sleeve your cards
- Measure one card: Use a ruler on a single unsleeved card and compare its width and length to 66 mm by 92 mm. Measure a card from the deck you actually plan to play, not a token or a card from a different game. If the card is more than about a millimeter wider than 66 mm, stop and choose a larger sleeve.
- Test-sleeve a single card: Slide one card into a The Wall sleeve and hold it face-down. The card should sit flat with a small border of sleeve visible on all four sides, and it should not bow or catch at the corners. A card that needs force to enter will bend at the top edge; try a different card before sleeving the rest.
- Check the top edge clearance: Look at how much sleeve extends above the card's top edge. Too little clearance lets the card ride up and pick up dirt; too much lets the card slide down and expose a corner. Compare the top gap to the side gaps; an uneven gap usually means the card is not seated fully.
- Sleeve the full deck in one pass: Work on a clean, dry surface and sleeve all 60 cards before shuffling. Keep the sleeve openings facing the same direction so the deck stays uniform and shuffles evenly. Count your deck against the 60-sleeve pack count before you start; a short count means you need a second pack.
- Store and re-check after play: Return cards to a deck box after each session and inspect the sleeve seams at the corners. Replace any sleeve that has split or picked up grit before the next game. Keep a few spare sleeves from a second pack so one split does not force a full re-sleeve.
Product facts
- Sleeves - Officially Licensed Attack on Titan Sleeves - The Wall: Officially licensed Attack on Titan sleeves listed at 66 mm wide and 92 mm long, with 60 sleeves per pack. Those dimensions match standard Magic-sized cards, and 60 sleeves cover one typical constructed deck with no spares.
Sleeves - Officially Licensed Attack on Titan Sleeves - The Wall
